OK, I figured out how to change the door settings in the .csv file. But what do I have to mod in the rw file for it to get o work?
Also, I don't see an R32 in the file library.
RW and CSV share the same codes in terms of route coding. The only exceptions is that RW uses @ signs, commas, and parentheses, whereas CSV uses periods, commas, and semicolons.
Look for the station command(In CSV, it's .sta and in RW, it's @sta.). I'll convert what error46146 said in the support forum for RW use.
@sta(1,2,3,4,5,6,7,8,9,10,11,12)
1 = station name
2 = arrival time (hh.mmss)
3 = departure time (hh.mmss)
4 = whether the train's Pass alarm sounds to alert the t/o to stop at the next stop; not used in the subway so leave it as 0
5 = -1 or "L" for left doors open; 0 none of the doors to open; 1 or "R" for right doors open
6 = indicates whether the departure signal should be red by default or not. 1 = red, 0 = not
7 = indicates safety system to be used; 0 = ATS, 1 = ATC
8 = sound that is played when doors open
9 = dwell time in the station including door open/closing times in seconds
10 = a number from 0-250 stating how many passengers are on the train (0 = none, 100 = normal, 250 = overcrowded)
11 = sound that is played when doors close
12 = (for openbve use only, although i'm not sure if RW supports this) which timetable should be shown for the station
Hope this helps.
BStyles